|
Entering a New Constant
These instructions are for entering a new
constant in programs used with any units except the C7C (controller) and
S7D6 (signal conditioner).
First, you will need to get the constant from your existing controller.
|
1. |
Turn the
system
ON.
|
|
2. |
After
system
is
running,
press F6
(RETUR)
|
|
3. |
Press F4
(CALIB)
|
|
4. |
Press F6
(EXIT)
|
|
5. |
Press F3
(CALIB)
|
|
6. |
The
controller
will ask
you for
the
password.
|
|
7. |
While
holding
down the
SHIFT
key type
SIGMA.
|
|
8. |
Release
the
SHIFT
key and
press
the
ENTER
key.
|
|
9. |
Press F2
and the
screen
will
show the
current
constant.
|
|
10. |
WRITE IT
DOWN.
|
|
11. |
Press
the
ENTER
key.
|
|
12. |
Press F6
(RETUR) |
Now remove the
existing
controller,
skipping the
part where you
remove the A/D
board. Now
install the new
sampler.
Now you will
have to enter
the constant
from your old
controller.
|
1. |
Follow
steps
1-9
above.
|
|
2. |
The
controller
will
display
the
current
constant.
|
|
3. |
Use the
(DEL)
key to
delete
any
unwanted
numbers.
|
|
4. |
Enter
the
constant
from the
original
controller.
|
|
5. |
After
new
constant
is
entered,
press
ENTER.
|
|
6. |
Press F6
(RETUR).
|
|
7. |
The new
constant
is
entered. |
|
|
